Keep product straight, remove the water tank cover and water cap in a vertical direction (water cap is attached to the water tank cover). Fig 1
Connect the AC adaptor to the bottom of the main body. Fig 2
Use the measuring cup to supply water (do not add high temperature water). Do not exceed the max line on the measuring cup. Do not add water when the product is on. Drop essential oil into the water tank vertically. Fig 3
Place the water tank cover back on the main body. Rotate the cover to adjust to the desired position of spray. The water tank cover must be on to use the product. Fig 4
Connect the AC adaptor to an outlet.
Press “MIST” button on the right and choose the time needed (1H, 3H, 6H or ON for continuous spray). Press “MIST” button five times to switch it off. Fig 5
Press “LIGHT” button to turn on the LED light. Seven light color options at varying brightness are available. Fig 6
Drain water from water tank and dry if not being used. A neutral detergent can be used to clean the water tank.
Even if plugged in, the product remains off unless the MIST button is pressed.
If there is a lack of water in the tank, the product will automatically turn off even if the MIST button is pressed.
MIST and LIGHT will automatically shut off when water runs out.
Fig 5 & 6
Product use time: 4 hours
The amount and intensity of mist produced will vary, but this is not unusual and should not be considered as a fault.
Factors that affect this include water type, humidity, temperature, and air currents.
Automatically powers off when water runs out.
Apply only 100% natural essential oils. If they contain chemical ingredients, flavors, or impurities it may cause damage to the product.
Before using another essential oil, follow the maintenance part of cleaning the product.
ACCIDENTAL LEAKAGE In the event of the unit being knocked or tipped over during use, follow the steps below to avoid malfunction.
Unplug the product and remove the cover.
Pour out any remaining water from the water tank.
Shake the main body and water tank gently to drain the water. Then let it air dry for at least 24 hours
MAINTENANCE After using 5-6 times, or after 3-5 days, clean the product as follows:
Unplug the product and remove the cover.
Pour out any remaining water from the tank.
Use a small amount of neutral detergent and warm water to wipe the water tank down gently. Use cloth to dry it lightly.
To avoid water flow into the air outlet, pour excess water out the left side of the water tank as shown in the left picture below.
Do not use other acids or enzymes detergents, as this may give off poisonous gas or cause malfunction.
Note: Be sure to use a mild detergent (like dish soap).
PRECAUTIONS Read below to avoid malfunction of this product:
Do not fill over 400ml max at any time.
Do not switch on power when the tank is empty.
Do not touch the ultrasonic vibration plate.
Clean regularly per maintenance instructions to avoid malfunction.
Always unplug from outlet before beginning maintenance.
After use, pour out remaining water from “drain side” of the water tank, and wipe with a dry cloth.
Essential oils can stain. In the event of a spill, wipe away with a dry, soft cloth.
Only use the measuring cup to add water into the tank. Do not fill water directly from the faucet.
Do not let mist blow onto furniture, clothing, walls, etc.
Keep away from direct sunlight, heat sources, air conditioners, and fans.
Always keep on a stable, flat surface. Do not place on carpet, duvet, or unstable area.
Keep away from electronic equipment such as TV and audio equipment.
Do not tip the product. This may cause water to enter the mechanism and cause a malfunction.
Product use time: 4 hours.
Wait 60 minutes before restarting to avoid damage to the ultrasonic plate.
Use tap water only. Do not use mineral water, sparkling water, etc.
Never move product while in use.
Do not touch any part of the product with wet hands.
Keep out of the reach of children and pets. The product is not suitable for children or persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction.
Keep cord clear of pathways. Do not pull forcefully on the cord at any point.
If there is smoke or a burning smell is detected, unplug immediately.
Will not switch on or off
No mist or abnormal mist
Water leakage from product
If product doesn’t work well, refer to the following points before requesting repairs
Is there enough water in the tank?
-add water to the tank
Is the power cord connected properly?
-Disconnect, check cables, reconnect carefully
Is there too much water in the tank?
- Do not fill over 400mL
Dirt on the ultrasonic plate?
-Refer to maintenance instructions to clean.
Dirt on the air suction port on the underside of the main body?
Cover and inner cover not installed properly?
-Remove and reinstall correctly
Low temperature or high humidity?
-Under these conditions, the mist may condense quickly into water droplets
HEALTH BEYOND THE SENSES COPYRIGHT 2022 SIXTH SCENTS ALL RIGHTS RESERVED.
The statements contained herein have not been evaluated by the Food and Drug Administration. Neither Sixth Scents nor its products are intended for the purpose of diagnosing, treating, curing, or preventing any disease. If you are pregnant, nursing, taking medication, or have a medical condition, consult your physician before using these products. Sixth Scents essential oils are intended for topical use only. For internal use always work with a certified aromatherapist or physician.